Microplex M204 Especificaciones descargar pdf (Pagina 99)

USING THE M204’S COMMAND SET: npsh Command Set 91

M204 can resolve the IP name. Please see set sysinfo on page 101 for more

information.

reset

Restore current settings to those stored in EEPROM. Performs a warm boot or

hardware reset, simulating a power-on reset. Use this after a power failure.

save

Save the current settings to EEPROM. These parameters include: system

information, destinations, models, logpaths, variables, I/O ports, and port-

maps. Resetting the unit is not required.

save default

Caution

This command overwrites everything and saves factory settings of all parame-

ters to EEPROM, except the factory-programmed Ethernet and Token Ring

addresses. The changes do not affect the current operating parameters until

the M204 is reset.

See also: load on page 89, reset on page 91, and Set Commands on page 91.

Set Commands

Change the current parameters. The three command possibilities are:

set

choice parameters

Set some parameters.

set

choice

from default Set default parameters.

set

choice

from stored Set stored parameters from EEPROM.

choice and parameters can be any of the following options described next.

Once you have set any parameters, you need to issue a save command to store

these new values to EEPROM.

Note

1 2 ... 94 95 96 97 98 99 100 101 102 103 104 ... 203 204

Sin comentarios

Microplex M204 Especificaciones Pagina 99