Microplex M204 Especificaciones Pagina 118

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 204
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 117
110 USING THE M204’S COMMAND SET: npsh Command Set
store tcpip
store tcpip
ifnum
addr
ipaddress
Store the ipaddress for the NIT module specified by ifnum.
ifnum is the Interface Number labelled on each of the M204’s PCMCIA slots.
store tcpip
ifnum
frametype [[-]ethernet2] [[-]802.2snap]
Control the frame type(s) used by the NIT module specified by ifnum.
store tcpip
ifnum
mask
netmask
Store the netmask for the NIT module specified by ifnum.
store tcpip
ifnum
opts [[-]rarp] [[-]bootp]
Enable or disable the RARP and BOOTP for the NIT module specified by
ifnum.
store tcpip opts [-]ipforward
Enables the IP forwarding or routing functions of the M204. By default, the
gateway is disabled. This command must be used in conjuction with the
store tcpip proxy command below.
store tcpip proxy add [host|net]
targetipaddress
[
/tar-
getnetmask
]
Enables the M204 to respond to ARP requests for IP addresses that are differ-
ent than the interface configuration of the M204.
store tcpip proxy del
targetipaddress
Removes this entry from the proxy ARP table.
store tcpip route add|del default
routeripaddress ifnum
Add or delete a default router entry in the M204’s routing table for the NIT
module specified by ifnum.
Note
Vista de pagina 117
1 2 ... 113 114 115 116 117 118 119 120 121 122 123 ... 203 204

Comentarios a estos manuales

Sin comentarios