Microplex M204 Especificaciones descargar pdf (Pagina 108)

100 USING THE M204’S COMMAND SET: npsh Command Set

[-]autofd Assert AUTOFD line for CR insertion. This only affects

printers that support this function.

[-]bbmode Simulate an attached printer even if a printer isn’t really

there.

[-]fastmode Increase transfer rate. The parallel interface of the attached

printer must be able to support this increased rate and if using

this mode, use only with short (less than two meter) low-

capacitance cabling.

[-]onlcr Enable [disable] carriage return insertion.

[-]opost Allow output processing such as onlcr, xtab, and descram-

bling. With “-”, do not allow any of this processin

[-]slowmode Slow the transfer rate to match that of a PC’s parallel port.

Might be necessary with older, slower laser printers.

[-]vslowmode Slow the transfer rate even more to accomodate certain

printers.

flush Flush the data in the parallel I/O port’s output buffer.

unlock Release the access lock on the parallel I/O port.

Caution

Using the unlock option when an I/O port is active can cause output from two

jobs to intermix.

set prn1|prn2 timeout <

INT

Terminate a print job sent to the parallel I/O port if it is not printed after the

timeout period (INT is time in minutes). If the timeout is set to zero (0), the

timeout feature is also disabled.

Printer errors will cause the M204 to postpone printing until the printer is

ﬁxed regardless of this timeout feature being set or not. Therefore, no data

will be lost.

Note

1 2 ... 103 104 105 106 107 108 109 110 111 112 113 ... 203 204

Sin comentarios

Microplex M204 Especificaciones Pagina 108