05/13/97 7
M202/M212 v5.6.3 Release Notes (Con’t)
bb Bit Bucket mode. Simulate an attached printer even
if one isn’t attached.
There is
no longer a setting to adjust the flow control method of the paral-
lel port from busy mode to ACK mode. This is no longer necessary.
Using the
old command syntax for the parallel ports will continue to
work with version 5.6.2 but this will eventually be phased out in future
firmware releases.
The following commands have been added to the “npsh” command shell:
set sysinfo module [-]novell [-]appletalk [-]netbios
Prior to version 5.6.3, only the Novell and AppleTalk stack could be
enabled or disabled within the M202/M212 allowing for easier memory
allocation or network broadcast control. However, with version 5.6.3 and
higher, the NetBIOS over TCP/IP protocol can now be controlled as well.
store tcpip tcp opts [-]disbufmgmt
Use this command to enable or disable receive buffer management on the
M202/M212. The receive buffer controls how many simultaneous TCP
connections can be allowed with the unit at one time. The only time you
may need to have receive buffer management turned off is if you notice
short pauses between the end of one print job and the start of the next job
usually with LPR printing.
store pserver opts [jobtimeout
seconds
]
This command only applies if a logpath setting is used for printer feed-
back (e.g. logpath type equals “printer” and “pgcnt” for printer errors and
pagecounting responses). Adjusting this seconds value will tell the print
server how long to wait for printer feedback at the end of a print job
before it continues on to the next print job in the queue. The default value
is 0 meaning it will hold indefinitely. Most printers should respond quite
quickly so you won’t need to adjust this value but if you have time-critical
printing happening (e.g. one job every 7 seconds) with certain logging
requirements, this may come into play.
Anytime you execute a “
store” command, you must reboot the print
server with a “reset” command or physically unplug and plug it back in.
Otherwise, the setting will not become a current or working setting in
memory.
CE Mark
The M202/M212 conforms with EU ENC Directive 93/68/EEC providing
that certain requirements are met by the end user. The requirements for
CE Mark conformity are:
1 Shielded cables must be used on all parallel and serial ports.
2 The included pink plastic caps must be placed securely over any
unused I/O ports.
o
e
o
e
New Commands
o
e
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales